Wolf 3d Help
#1
ok the only thing thats stopping me from starting my fc is i have a no coms problem from the pc to the ecu. the program only says P looking for ecu. this happens on all ports and all rates. i got a call out to chris greene but he hasnt responded yet so here i am. i have loaded and unloaded the 2 disk set up as well as the software from wolf home page many times, still all the same result. anyone have any ideas, could i have a bad cable, bad port , bad ecu? im frustrated at something so simple, and i do not wish to start from scratch via the hand controler on a blank map.
anyone that can help please do. i need this problem solved this weekend so i can break the re motor in intime to run a few pounds of boost at full rpm levels at elkart for the mazda show. or atleast so i can drive the car there and show it.
anyone that can help please do. i need this problem solved this weekend so i can break the re motor in intime to run a few pounds of boost at full rpm levels at elkart for the mazda show. or atleast so i can drive the car there and show it.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)