Starting A Wolf 3d Install
#1
The wiring harness is wired all funky. Fuses are right next to the ECU pin connector, relays are at different distances, not 1 loom but several. Wire groupings really odd. So far the haltech blows it out of the water. Final impressions will be given when its installed and we are done tuning.
#4
is this a used wolf or a new?
I would rather make my own harness
wouldnt you rather the fuse as close to the power
source as possible?
people who have the wolf love it and have no problems
with it
13b ace had one, and I think mazdadrifter has one too?
I would rather make my own harness
wouldnt you rather the fuse as close to the power
source as possible?
people who have the wolf love it and have no problems
with it
13b ace had one, and I think mazdadrifter has one too?
#6
?? that has to be a pre- 4.0
the only "different looming" was the ignition triggers were loomed together and the cas wires were together. I thought it made for a cleaner install, considering the ignitor is allways away from the engine, and the cas gets it's own black looming that goes across the motor. I thought it made for a cleaner install.
to each his own i guess?
the only "different looming" was the ignition triggers were loomed together and the cas wires were together. I thought it made for a cleaner install, considering the ignitor is allways away from the engine, and the cas gets it's own black looming that goes across the motor. I thought it made for a cleaner install.
to each his own i guess?
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)