Care to enlighten us oh great one?

 

I wanted to show which fuel pump I'm going to use, but I lost the link and was too tired to look it up.



Here it is. http://store.summitracing.com/partdetail.a...t=CRT%2DP4600HP

 

i have one of those, what its gonna end up in is open to debate however

 

I have two, actually. One is for the REPU so when it gets a supercharger (if it ever does), it'll have enough volume. The other should do well with a carb on the 20B.



The upper manifold arrived today and I started test fitting it. It looks like the rear lifting hook and some excess aluminum will have to be trimmed.

 

no biggie

 

I hope you can rig that UIM for a sidedraft setup.That would look PIMP

 

The two barrels of the sidedraft carb look like they'll match the two upper intake holes of the UIM. I'll try to match it to all three with an adapter.

 

Are you gonna go weber DCOE,Mikuni or Dellorto?They all show up from time to time on egay.Theres a 40mm DCOE but the owner says its too small for his street ported 13b so that mean way to small for a 20B

 

Dellorto 48 DHLA. It'll be really close to the hood.



I chopped some aluminum today. The only thing still in the way is the hood latch. I'm not sure what I'm going to do about it at this time. I'll probably leave it 'til later. I'd like to get the 20B running really soon. I'm also trying to get the 13B for the white truck ready to rebuild.

 

i think a modded t2 tb elbow might work for that