13b Conversion
#1
My 79 is already modified, but, i now have a GSLSE donor car. I an pulling all the running gear, trans, and motor. this motor is un know condition. I have a 13b from another GSLSE in the garage. I will pull all of the wiring harness.
My question is: I would like to run the fuel injection. I will not be swapping dashes. Has any one else done the swap and what wires need to be patched in to run the ECU?
I will have 2 LSD rearends up for trade/sale, 81/82, front spindles 81, 3 12a trans 81, 82, 84. 12a motor with rb header, and Mikuni side draft. 7.6 on the Mazda compression tester. I have six 79/80 honeycomb rims. Time to clean garage again.
My question is: I would like to run the fuel injection. I will not be swapping dashes. Has any one else done the swap and what wires need to be patched in to run the ECU?
I will have 2 LSD rearends up for trade/sale, 81/82, front spindles 81, 3 12a trans 81, 82, 84. 12a motor with rb header, and Mikuni side draft. 7.6 on the Mazda compression tester. I have six 79/80 honeycomb rims. Time to clean garage again.
#3
Talk to '79Rx7 He has his 79 looking stock inside(besides the roll bar and a few extras) but his is powered by a 86 13b with the 86 EFI and ECU on his stock dash setup.He should be able to help you alot.Is that your car in your avatar?What kit is that?
#4
Yes, that is my car. It is a kit by Erubuni. I am in the panhandle of Florida.
I have looked into too. I beleive i only need six or seven wires to run the ecu. As soon as i get done stripping this car i will inquire more.
I have looked into too. I beleive i only need six or seven wires to run the ecu. As soon as i get done stripping this car i will inquire more.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)