My 79 is already modified, but, i now have a GSLSE donor car. I an pulling all the running gear, trans, and motor. this motor is un know condition. I have a 13b from another GSLSE in the garage. I will pull all of the wiring harness.

My question is: I would like to run the fuel injection. I will not be swapping dashes. Has any one else done the swap and what wires need to be patched in to run the ECU?

I will have 2 LSD rearends up for trade/sale, 81/82, front spindles 81, 3 12a trans 81, 82, 84. 12a motor with rb header, and Mikuni side draft. 7.6 on the Mazda compression tester. I have six 79/80 honeycomb rims. Time to clean garage again.

ive looked into this a little bit and the gsl-se ecu just needs a few powers and grounds, and a tach signal, its not a huge deal.

where are you located?



mike

Talk to '79Rx7 He has his 79 looking stock inside(besides the roll bar and a few extras) but his is powered by a 86 13b with the 86 EFI and ECU on his stock dash setup.He should be able to help you alot.Is that your car in your avatar?What kit is that?

Yes, that is my car. It is a kit by Erubuni. I am in the panhandle of Florida.

I have looked into too. I beleive i only need six or seven wires to run the ecu. As soon as i get done stripping this car i will inquire more.