FS: HIghly modded RX7 Turbo in MN
#1
[attachment=39128:attachment][attachment=39126:attachment][attachment=39124:attachment]FS: MAZDA RX7 Highly Modded!! in MN
--------------------------------------------------------------------------------
I have an 1986 gxl converted to turbo. I will list the mods that it has plus the spare parts i`ve acquired.
1986 gxl white w/ burgandy interior...interior is almost perfect!! Car has a aluminum non-turbo hood that is flat black, tII aero mirrors, TII rear spoiler. It has 4 piston caliupers that are powder coated red. Wiper switch has been repaired, cpu resoldered, and all grounds redone Body has a few small dents and scratches, but over all it is really nice. I`ve rewired the fuel pump, installed a custom fmic, and e-fan. power window and switches all work too. All emisions have been removed, block off plates installed....I`m also running pre-mix.
e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.
I`m located in fergus falls, MN
88 j-spec motor, 120psi per rotor face
BNR staqe III s5 turbo, less than 6000 miles
3" Racing beat down pipe w/ pre silencer, 3" custom dual exhaust
electric fan w/ thermostat control
fmic w/ 2.5" piping
GREDDY BOV
GREDDY elbow
ACT clutch, pressure plate, throw out bearing....less than 3000 miles
13# light weight steel flywheel
RTEK 1.7 ecu
Crane hi-6 ignition
1st gen. APEXI S-AFC
2-720 low imp GREDDY injectors.....3 months old
2-890 low imp MARREN injectors.....3 months old
AEM wide band o2
stewart warner boost gauge
10mm magnecor wires
optima red top....relocated to pass. bin
miata short shift w/ vodoo ****
racing beat springs w/ tokico blue struts
alpine stereo w/ 12" sub
fire exstiguisher
255 walbro fuel pump...rewired
3rd gen ALT.
autovation rx7 turbo billet aluminum pedals
momo trek knock off steering wheel w/ hub
yahoo belt
h4 conversion headlights
aluminuim radiator panel
new plugs
17" 15 spoke rims w/ almost new fusion 235/50/17
Here are the spare parts that come with this car....
1- rebuildable TII motor w/ bad oil seals
1- good tII tranny
1- n/a tranny
TII hood w/ scoop
n/a steel hood
rear hatch with wiper
2- tmic
2- stock bovs
2-tps
3- sets of coils
TII fuel pump
n/a fuel pump
2 wiper switches
1 set of window switches
1 set power window regulators
1 set ftp lenses...no cracks or scratches
tilt steering wheel
clutch pedal assembly
6-puck unsprung clutch w/ pp
2 TII flywheels w/ stock clutch assemblies
2- n/a uim, lim and tbs
1- TII uim, and lim
3- s4 alternators
1- s6 alternator
2 -tuarus e-fans
3 -stock clutch fans
2- shrouds
1- n/a to turbo exhaust spacer
lots of gray interior pieces.....I have 6 30x 54x 15 bins full of s4 rx7 parts.
I bought a new toyota tundra, and its time to move on....car is fast, but could be faster with a good stand alone setup....SAFC is too hard t tune!! I have well over $7000 in mods alone...asking $4200 obo, plus you get almost 2 of everything as far as spare parts.
e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.
I alos it listed on ebay..... http://cgi.ebay.com/ebaymotors/ws/e....AMESE%3AIThave
--------------------------------------------------------------------------------
I have an 1986 gxl converted to turbo. I will list the mods that it has plus the spare parts i`ve acquired.
1986 gxl white w/ burgandy interior...interior is almost perfect!! Car has a aluminum non-turbo hood that is flat black, tII aero mirrors, TII rear spoiler. It has 4 piston caliupers that are powder coated red. Wiper switch has been repaired, cpu resoldered, and all grounds redone Body has a few small dents and scratches, but over all it is really nice. I`ve rewired the fuel pump, installed a custom fmic, and e-fan. power window and switches all work too. All emisions have been removed, block off plates installed....I`m also running pre-mix.
e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.
I`m located in fergus falls, MN
88 j-spec motor, 120psi per rotor face
BNR staqe III s5 turbo, less than 6000 miles
3" Racing beat down pipe w/ pre silencer, 3" custom dual exhaust
electric fan w/ thermostat control
fmic w/ 2.5" piping
GREDDY BOV
GREDDY elbow
ACT clutch, pressure plate, throw out bearing....less than 3000 miles
13# light weight steel flywheel
RTEK 1.7 ecu
Crane hi-6 ignition
1st gen. APEXI S-AFC
2-720 low imp GREDDY injectors.....3 months old
2-890 low imp MARREN injectors.....3 months old
AEM wide band o2
stewart warner boost gauge
10mm magnecor wires
optima red top....relocated to pass. bin
miata short shift w/ vodoo ****
racing beat springs w/ tokico blue struts
alpine stereo w/ 12" sub
fire exstiguisher
255 walbro fuel pump...rewired
3rd gen ALT.
autovation rx7 turbo billet aluminum pedals
momo trek knock off steering wheel w/ hub
yahoo belt
h4 conversion headlights
aluminuim radiator panel
new plugs
17" 15 spoke rims w/ almost new fusion 235/50/17
Here are the spare parts that come with this car....
1- rebuildable TII motor w/ bad oil seals
1- good tII tranny
1- n/a tranny
TII hood w/ scoop
n/a steel hood
rear hatch with wiper
2- tmic
2- stock bovs
2-tps
3- sets of coils
TII fuel pump
n/a fuel pump
2 wiper switches
1 set of window switches
1 set power window regulators
1 set ftp lenses...no cracks or scratches
tilt steering wheel
clutch pedal assembly
6-puck unsprung clutch w/ pp
2 TII flywheels w/ stock clutch assemblies
2- n/a uim, lim and tbs
1- TII uim, and lim
3- s4 alternators
1- s6 alternator
2 -tuarus e-fans
3 -stock clutch fans
2- shrouds
1- n/a to turbo exhaust spacer
lots of gray interior pieces.....I have 6 30x 54x 15 bins full of s4 rx7 parts.
I bought a new toyota tundra, and its time to move on....car is fast, but could be faster with a good stand alone setup....SAFC is too hard t tune!! I have well over $7000 in mods alone...asking $4200 obo, plus you get almost 2 of everything as far as spare parts.
e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.
I alos it listed on ebay..... http://cgi.ebay.com/ebaymotors/ws/e....AMESE%3AIThave
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)