SlIcK WiLlIe

[attachment=39128:attachment][attachment=39126:attachment][attachment=39124:attachment]FS: MAZDA RX7 Highly Modded!! in MN



--------------------------------------------------------------------------------



I have an 1986 gxl converted to turbo. I will list the mods that it has plus the spare parts i`ve acquired.



1986 gxl white w/ burgandy interior...interior is almost perfect!! Car has a aluminum non-turbo hood that is flat black, tII aero mirrors, TII rear spoiler. It has 4 piston caliupers that are powder coated red. Wiper switch has been repaired, cpu resoldered, and all grounds redone Body has a few small dents and scratches, but over all it is really nice. I`ve rewired the fuel pump, installed a custom fmic, and e-fan. power window and switches all work too. All emisions have been removed, block off plates installed....I`m also running pre-mix.

e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.



I`m located in fergus falls, MN





88 j-spec motor, 120psi per rotor face

BNR staqe III s5 turbo, less than 6000 miles

3" Racing beat down pipe w/ pre silencer, 3" custom dual exhaust

electric fan w/ thermostat control

fmic w/ 2.5" piping

GREDDY BOV

GREDDY elbow

ACT clutch, pressure plate, throw out bearing....less than 3000 miles

13# light weight steel flywheel

RTEK 1.7 ecu

Crane hi-6 ignition

1st gen. APEXI S-AFC

2-720 low imp GREDDY injectors.....3 months old

2-890 low imp MARREN injectors.....3 months old

AEM wide band o2

stewart warner boost gauge

10mm magnecor wires

optima red top....relocated to pass. bin

miata short shift w/ vodoo ****

racing beat springs w/ tokico blue struts

alpine stereo w/ 12" sub

fire exstiguisher

255 walbro fuel pump...rewired

3rd gen ALT.

autovation rx7 turbo billet aluminum pedals

momo trek knock off steering wheel w/ hub

yahoo belt

h4 conversion headlights

aluminuim radiator panel

new plugs

17" 15 spoke rims w/ almost new fusion 235/50/17



Here are the spare parts that come with this car....

1- rebuildable TII motor w/ bad oil seals

1- good tII tranny

1- n/a tranny

TII hood w/ scoop

n/a steel hood

rear hatch with wiper

2- tmic

2- stock bovs

2-tps

3- sets of coils

TII fuel pump

n/a fuel pump

2 wiper switches

1 set of window switches

1 set power window regulators

1 set ftp lenses...no cracks or scratches

tilt steering wheel

clutch pedal assembly

6-puck unsprung clutch w/ pp

2 TII flywheels w/ stock clutch assemblies

2- n/a uim, lim and tbs

1- TII uim, and lim

3- s4 alternators

1- s6 alternator

2 -tuarus e-fans

3 -stock clutch fans

2- shrouds

1- n/a to turbo exhaust spacer



lots of gray interior pieces.....I have 6 30x 54x 15 bins full of s4 rx7 parts.



I bought a new toyota tundra, and its time to move on....car is fast, but could be faster with a good stand alone setup....SAFC is too hard t tune!! I have well over $7000 in mods alone...asking $4200 obo, plus you get almost 2 of everything as far as spare parts.



e-mail me at..bandedgandr@hotmail.com I perfer e-mails rather than posts or pms.



I alos it listed on ebay..... http://cgi.ebay.com/ebaymotors/ws/e....AMESE%3AIThave