mazda se

Iv got an 88 mazda b2200 and the engine is on its way out.I was wondering if there was a wrtie up on how to swap a 13b into the truck,Iv seen it done before and wanted to know how to do it for my truck.





thanks

jake

vosko

there is no official write up for it.....

Goopy

[quote name='mazda se' date='May 15 2005, 08:39 AM']Iv got an 88 mazda b2200 and the engine is on its way out.I was wondering if there was a wrtie up on how to swap a 13b into the truck,Iv seen it done before and wanted to know how to do it for my truck.

thanks

jake


[/quote]





I have one with a swap..what do you want to know ..be more specific..

Jonathan

B200013B

[quote name='Goopy' date='May 16 2005, 04:43 PM']I have one with a swap..what do you want to know ..be more specific..

Jonathan


[/quote]





PMed you.... I am also interested in sourcing a nice 13B truck project that will be fun to drive as well as make some Home Depot runs that my RX7 cant quite cut

Jeff20B

Judge Ito and Dan Atkins have done it. The one I listed for a friend was converted by a local shop. I didn't do any of the mechanical work. All I did was ignition. Any info I had about it was listed in the for sale thread some time ago.



It was sold back to the shop that converted it. It received a reupulstered seat and a few other subtle upgrades. It may be currently for sale again.

B200013B

[quote name='Jeff20B' date='Jul 20 2005, 04:11 AM']Judge Ito and Dan Atkins have done it. The one I listed for a friend was converted by a local shop. I didn't do any of the mechanical work. All I did was ignition. Any info I had about it was listed in the for sale thread some time ago.



It was sold back to the shop that converted it. It received a reupulstered seat and a few other subtle upgrades. It may be currently for sale again.


[/quote]





To be honest I want this project to be as simple as possible.... if I can run the 13B old school.... no ECU no nothing except a carb, fuel pump, and ignition that would be great.



My biggest concern is the motor mounts.... I have gathered from searching that I need to use the GSL-SE motor due to mounts located on the front housing.



Just trying to gather up info to start sourcing parts...

75 Repu

easiest way is to go old carb motor.. and those come with the engine mounts on the front cover.. so you just need to weld up a crossmember on the front to the frame. basically like an original repu had..