when your talking and rushing ,its the little things that go awry.Then you you got to buy another.Fucked up and THEN I got even!(not really I had to buy a new one)

 

last one for you port hoars!!!Its all about blowing!

 

Art I see said the blind man. Yes you need it a new plate.

 

Where I can get this porting templates from

 

Pretty big. Is it me, or is the shape of the intake ports kinda weird?

 

whats the heat exchanger for.

 

I got the templete years ago. I posted a pick in the porting section.(Bridge port is one of two) Maybe page 8 or 9.

As long as I did not go beyond the template edge(dye marked) its should be fine.

I still need to match the front side to the rear in flow size but its still in parameters.

The intermediate is taken from the same template , when positioned between the eccen. hole the dowl pin holes (top & bottom) spray dye of template then ported but never to the size of the standered big port. (We know its not constructed for this).

As far as getting templates I respect Judge Ito to be the one to ask on that ,but if it was financially worth my while i could probably get some made at a machine shop.

But like most of us its the personal time to get that done, pay the machinist and then to get it shipped out , cause I dont have a business any more.

Later