Pick Of Porting
#17
Originally Posted by FD-Driver' date='Jan 18 2003, 08:42 PM
Where I can get this porting templates from
As long as I did not go beyond the template edge(dye marked) its should be fine.
I still need to match the front side to the rear in flow size but its still in parameters.
The intermediate is taken from the same template , when positioned between the eccen. hole the dowl pin holes (top & bottom) spray dye of template then ported but never to the size of the standered big port. (We know its not constructed for this).
As far as getting templates I respect Judge Ito to be the one to ask on that ,but if it was financially worth my while i could probably get some made at a machine shop.
But like most of us its the personal time to get that done, pay the machinist and then to get it shipped out , cause I dont have a business any more.
Later
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)