86 Na 6 Port Rebuild
#13
Originally Posted by 88IntegraLS' date='Feb 17 2003, 03:56 AM
Do any of you measure the length of the apex seal when gluing on the corner piece? Isn't it supposed to be the same as the width of the housing minus the standard clearance?
Oh yeah, 85 and before 13Bs had a factory clearance which was even greater. The 85 manual says they are 79.8mm in total length.
So I concluded, there is no hard and fast rule. 0.2mm seems a lot but my 85 GSL-SE has 200K miles and still runs like champ (outruns any 2nd gen n/a) and has decent compression. Obviously they did something right on the 84-85 13bs because almost all of them seem to have lasted well over 200k miles.
Thread
Thread Starter
Forum
Replies
Last Post
TweakGames
Rotary Engine Building, Porting & Swaps
25
10-14-2007 12:10 AM
estrada42
Rotary Engine Building, Porting & Swaps
1
01-31-2007 06:21 AM
Comitatus
2nd Generation Specific
1
02-06-2003 07:11 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)