Rotary Miata?
09-25-2003, 10:50 PM
#1
Junior Member
Thread Starter
Join Date: Sep 2003
Location: Alabama
Posts: 0
Is it possible to fit a 13B Twin Turbo into a '99 Miata? If so.. what new parts/ mounts would I need besides the engine (DUH 
09-25-2003, 10:56 PM
#3
Senior Member
Join Date: Aug 2002
Location: Reno,NV
Posts: 1,081
simple answer is yes...it has been done a few times in japan saw it in option mag. its a chicks car..now what you need would be a standalone ecu eng mounts tranny mounts drive shaft (rear end) not sure on that one..and someone who knows alot about custom fabing
good luck
good luck
09-26-2003, 03:54 AM
#4
Senior Member
Join Date: Oct 2002
Location: Perth, Western Australia
Posts: 343
We have built two here.
Like anything, can be done but would be expensive if you paid for the work rather than did it. When you stick a 13Bt in there it's noticable that there are shapes & recesses in the body pressings that line up with RE bits like the turbo compressor & clutch fork.
Mazda definately were thinking about it........should have made them!
Like anything, can be done but would be expensive if you paid for the work rather than did it. When you stick a 13Bt in there it's noticable that there are shapes & recesses in the body pressings that line up with RE bits like the turbo compressor & clutch fork.
Mazda definately were thinking about it........should have made them!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)