;)Is it possible to fit a 13B Twin Turbo into a '99 Miata? If so.. what new parts/ mounts would I need besides the engine (DUH https://www.nopistons.com/forums/pub..._DIR ), Mounts, and custom exhaust manifold? Also... are there any aftermarket mounts that i could buy.. or would i have to make them...

Anything is possible, dont c why not.

simple answer is yes...it has been done a few times in japan saw it in option mag. its a chicks car..now what you need would be a standalone ecu eng mounts tranny mounts drive shaft (rear end) not sure on that one..and someone who knows alot about custom fabing

good luck https://www.nopistons.com/forums/pub...#>/BURNOUT.gif

We have built two here.

Like anything, can be done but would be expensive if you paid for the work rather than did it. When you stick a 13Bt in there it's noticable that there are shapes & recesses in the body pressings that line up with RE bits like the turbo compressor & clutch fork.

Mazda definately were thinking about it........should have made them!

Mazda's hydrogen powered MX-5 had a rotary in it. https://www.nopistons.com/forums/pub...IR#>/smile.png