Non Seq Help
02-27-2005, 04:25 PM
#1
Senior Member
Thread Starter
Join Date: Dec 2003
Location: scotland uk
Posts: 472
i was just wonderign what is best ive been told to weld the flap on the exaust manifold open for the ns mod but would it not be better to take it off and weld up the hole? i have a feeling the flap might be a bit restrictive but would it be better there or not there. cheers jonny
03-02-2005, 04:56 PM
#3
Guest
Posts: n/a
Originally Posted by yonner' date='Feb 27 2005, 04:25 PM
i was just wonderign what is best ive been told to weld the flap on the exaust manifold open for the ns mod but would it not be better to take it off and weld up the hole? i have a feeling the flap might be a bit restrictive but would it be better there or not there. cheers jonny
The best is to remove the flapper from the exhaust manifold and tap and plug the hole with a threaded cast iron plug. This has been the best rule since day 1 of going full non-seq. Anything other is just a joke.
Also work on the #2 exhaust port into the turbo housing where the gate use to mate up against. Cutting back and rounding the edges also helps reduce back pressure and helps spool up.
If you are going non-seq, do it correctly or not at all!
Thread
Thread Starter
Forum
Replies
Last Post
neoamd
3rd Generation Specific
13
12-31-2003 08:55 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)