Damn Non-seq =/
#2
Ok, Ive narrowed it down to these. MAP sensor (someone have a pic?), the fuel pressure regulator*, and the wastegate actuator, and the PCV valve (need pic also).
*Already ran the 6-8 inches of hose, done!
Im going to run a MBC (a hallman or Joe P). I know how to set it up. I think.. I just need some help with where the map sensor and where the hell and what the PCV is. What do i do with the two hose plug thing that are on the front top of the UIM? D'oh..
TIA
Josh
*Already ran the 6-8 inches of hose, done!
Im going to run a MBC (a hallman or Joe P). I know how to set it up. I think.. I just need some help with where the map sensor and where the hell and what the PCV is. What do i do with the two hose plug thing that are on the front top of the UIM? D'oh..
TIA
Josh
#6
Damn man Search some haaa haaa
http://www.scuderiaciriani.com/rx7/non-sequential.html
http://www.dontbearikki.com/id49.htm
The" two hose plug things" are the pre control and the wastegate solinoids that go to the actuators.
Keep the wastegate plug the precontrol..
http://www.scuderiaciriani.com/rx7/non-sequential.html
http://www.dontbearikki.com/id49.htm
The" two hose plug things" are the pre control and the wastegate solinoids that go to the actuators.
Keep the wastegate plug the precontrol..
#8
dude thanks, im am doing FULL non-seq.
No solinoid rack, ported w/g, precontrol cut out and hole shut, tca door cut and welded off. I have a friend here with the same mods as me but he is seq. We are going to do runs from a stop, 40mph, 60mph, and 80mph roll to see how each perform. Both runs will be at 12lbs. Should prove FULL non-seq superior
Josh
No solinoid rack, ported w/g, precontrol cut out and hole shut, tca door cut and welded off. I have a friend here with the same mods as me but he is seq. We are going to do runs from a stop, 40mph, 60mph, and 80mph roll to see how each perform. Both runs will be at 12lbs. Should prove FULL non-seq superior
Josh
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)