Clip Problem. Need Input
#1
I had to cut a clip to be able to extend it over to the driverside of the engine bay.
I tossed the clip and decided to solder the wires to the sensor, that it was previously attached too.
The check engine light for it is going off. I double checked the connections. Everything should be working fine.
Im starting to wonder if the CLIP needs to be attached to the sensor for some reason?
anyone know?
I tossed the clip and decided to solder the wires to the sensor, that it was previously attached too.
The check engine light for it is going off. I double checked the connections. Everything should be working fine.
Im starting to wonder if the CLIP needs to be attached to the sensor for some reason?
anyone know?
#3
I'm curious if the heat from the soldering damaged the sensor internals. Otherwise, no - the clip only plays the role of holding the connectors securely. Maybe there is a procedure for checking the resistance of the sensor, seeing if it has failed.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)