What Knob Will Fit The Mazdatrix Shifter
#31
http://www.engineersedge.com/tap_drill_chart.htm
Of Course that info conflicts with the chart in Machinery's handbook. For a 12 x 1.5 thread, the Z drill would be acceptable. My apologies ROB!
Of Course that info conflicts with the chart in Machinery's handbook. For a 12 x 1.5 thread, the Z drill would be acceptable. My apologies ROB!
#32
Originally Posted by banzaitoyota' date='Jan 27 2005, 10:14 AM
I CALL SHENANIGANS ON THREAD ABUSE!!!!!!!!! Unless you like it loose and sloppy!
Standard Drill size for M12 Nominal size and thread diameter is 10.20mm (.4015")(recommended) and 10.40mm[.4094] (Alternate)
Z bit diameter 0.4130"
Standard Drill size for M12 Nominal size and thread diameter is 10.20mm (.4015")(recommended) and 10.40mm[.4094] (Alternate)
Z bit diameter 0.4130"
Originally Posted by banzaitoyota' date='Jan 27 2005, 11:36 AM
http://www.engineersedge.com/tap_drill_chart.htm
Of Course that info conflicts with the chart in Machinery's handbook. For a 12 x 1.5 thread, the Z drill would be acceptable. My apologies ROB!
Of Course that info conflicts with the chart in Machinery's handbook. For a 12 x 1.5 thread, the Z drill would be acceptable. My apologies ROB!
the Snap On metric tap and die set will give you the drill bit of Z to be used, which I did, and I then tapped it with a 12x1.5 tap, its been on my car for years now
I was going off real world expierence, not internet mumbo jumbo.
Thread
Thread Starter
Forum
Replies
Last Post
arkadyzv
RX-7 & RX-8 Parts For Sale & Wanted
1
11-09-2006 02:39 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)