Tranny swap
#1
Hey guys I finally got into my friends garage to do the swap. I was working on it tonight and found that I couldn't get the nuts and bolts holding the drive shaft on to break loose. I've tried an air rachet and penatrating spray(WD-40). Does anybody have any suggestions on a better way to get these to come loose?
#2
wd 40 isn't penetrating spray, get some PB blacster, hit it with a real impact wrench and if you have to heat it with a torch, but I have never had an issue with driveshaft bolts... how many ft/lbs revers is the impact? Mine is 650 and it will either remove the nuts or spin the bolts
#4
Originally Posted by phinsup' date='Sep 14 2002, 03:35 AM
wd 40 isn't penetrating spray, get some PB blacster, hit it with a real impact wrench and if you have to heat it with a torch, but I have never had an issue with driveshaft bolts... how many ft/lbs revers is the impact? Mine is 650 and it will either remove the nuts or spin the bolts
#5
I got them off yesterday. I just couldn't fit the impact gun in there. I had to go buy a universal joint. I was just checking to see if there was a different way to go about it. Thanks though.
Thread
Thread Starter
Forum
Replies
Last Post
CrazyAssRX7
2nd Generation Specific
21
12-15-2002 05:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)