i am new to the forum and i need some advice. i am putting an 89 intake setup in my n/a 88 gxl. i am also removing the emissions junk and modifying the tb.

on the steel vacuum spider, under the center section of the manifold, there is a small 5 port manifold that comes off a steel section between the hoses that go to the aws. can i connect a vacuum hose to the lim, in the center near the oil nozzles, to that manifold and then connect each of the oil nozzles to that manifold?

on the center section of the manifold there are two vacuum ports, a large one and a right angle one. i know where the right angle one goes, but where does the larger one go?

i also used one of the bac hoses to connect the water outlet on the rear rotor housing to the water outlet on the water pump housing. will this be okay?