Rob x-7

the guy who owned it decided he wanted a new car, he just parked it and never drove it again, I did try pushing the pedal in and out a bunch of times, Ill have to put it up and check it out

RONIN FC

The T/O could be stuck on its slide, but usually the pedal stays to the floor.



Put it in 4th and push the car by hand to see if the motor turns. Give you an idea if the clutch is engadging. 4th is usually the last surviving gear in a big failure.

j9fd3s

ralphs volvo had the clutch disc die, it happened all at once. basically he drove home, and on the way back to work, the disc screwed up. car barely moved

Cheers!

so all it does it just revs in gear?



I don't think it's the throw out bearing. The throwout bearing is used to push on the fingers of the pressure plate to release the clutch disc from the flywheel.



I would say either the clutch disc is fubar and is slipping like there is no tommorrow. Or there is something wrong with the tail section of the tranny and the shift forks causing you to not leave neutral in the tranny.

Rob x-7

its like its in neutral, there is no load on the engine, the car does not move at all, no action or smells come from the car if you rev it in gear

slayerx7

HAHAHA

How Ironic!

MY 83' is doing exactly the same thing. I know its the clutch. I thought maybe it might be a defective slave cylinder, so I took it off, and same thing. The car goes nowhere in any gear. Unfortunatly mine decided to stop engaging the engine while I was on the freeway. EXACT same symptoms as yours. At first though I could smell burning clutch, but after a point no smells at all.

Ill bet $100 that your pressure plate diaphram is the culprate. just worn out. So it doesnt have enough tension to push your friction disc to the flywheel.

However, www.rx7.com Sells some Bonez Racing clutch's for a good deal! 100% more clamping force than stock

slayerx7

Also I forgot to add, that right before it started to go it was slipping real bad, Like Id have to rev it up to 6000RPM just for it to catch a little.

Rob x-7

I have a spare stock clutch set up I can throw in there for now

Cheers!

can you select 1st or any gear while the engine is idling? or can you only select a motion gear when the engine is off?



if the case i'm describing is correct you have a hdraulic problem...



if you can select a motion gear while the engine is running and when you go release the clutch pedal and you step on teh gas and you can't go anywhere. It's either the slave is stuck and continually pushing the pressure plate and not letting the clutch disc make contact with the flywheel... OR... the clutch disc doesn't exist anymore and is in 1000 little peices.... But you should hear a grinding or bad sound of the disc is FUBAR.

Rob x-7

there is no noise, the fork is moving back and forth, I can shift into gears but its a little tough, it goes