2nd Generation Specific 1986-1992 Discussion

Possible Bad Tranny?

Old Feb 9, 2005 | 08:13 AM
  #1  
brett vance's Avatar
Thread Starter
Member
 
Joined: Jul 2004
Posts: 89
From: Orange County, NY
Default

Tranny might be shot, but not sure. It won't go into gear. Tranny is manual shift. stuck in nuetral. I backed the car up ok, went to put in first and wouldn't go, as a matter of fact it wouldn't go into anygear, not even back in reverse. Any suggestions as to what to look for? If i can repair or replace a part without replacing the tranny I just might. As a second question, if tranny is bad, where can I get a rebuilt or new tranny for my '86 gxl?
Old Feb 9, 2005 | 08:59 AM
  #2  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

so its stuck in reverse? try loosening the backup light switch, it unscrews. if that fixes it add a washer between it and the trans
Old Feb 9, 2005 | 09:01 AM
  #3  
phinsup's Avatar
Administrator
 
Joined: Jul 2001
Posts: 24,416
From: Stuart, FL
Default

Can you put it in gear with the engine off?
Old Feb 9, 2005 | 11:01 AM
  #4  
sureshot's Avatar
Senior Member
 
Joined: Feb 2004
Posts: 363
From: Orange Park FL
Default

Just to verify the symtoms:

The shift lever is in neutral but the tranny is in Reverse?
Old Feb 9, 2005 | 04:04 PM
  #5  
brett vance's Avatar
Thread Starter
Member
 
Joined: Jul 2004
Posts: 89
From: Orange County, NY
Default

Originally Posted by j9fd3s' date='Feb 9 2005, 10:58 AM
so its stuck in reverse? try loosening the backup light switch, it unscrews. if that fixes it add a washer between it and the trans





Originally Posted by phinsup' date='Feb 9 2005, 11:01 AM
Can you put it in gear with the engine off?





Originally Posted by sureshot' date='Feb 9 2005, 01:00 PM
Just to verify the symtoms:

The shift lever is in neutral but the tranny is in Reverse?





1 answer for each post.

Im not exactly sure that it is stuck in reverse, unless I just described the symptoms of a vehicle stuck in reverse.



I can put the vehicle into gear while it is off, however when the vehicle is on, nuetral is all I can get.



so to say that it's stuck in reverse I can't. But to say that the last gear I had it in was reverse, prior to the tranny doing what it's doing. I can say YES. I was backing the car out of my garage, I took the car out of reverse and went to put it into first gear and thats when I couldn't get any gear to work. I can put it in gear with the car off, but if I leave it in gear and turn it on, I tryed once and the car stalled out right away.Engine turned right back over on a restart but I couldn't get the car to move.



Maybe this might help. With the car off and set to nuetral it rolled back into the garage very easy. If it were stuck in reverse I don't believe I could do that?.



brett
Old Feb 9, 2005 | 04:17 PM
  #6  
Seppuku's Avatar
Senior Member
 
Joined: Mar 2002
Posts: 2,723
From: Ky
Default

If it was stuck in reverse it wouldnt roll something with your clutch is messed up.
Old Feb 9, 2005 | 06:30 PM
  #7  
89 Rag's Avatar
Senior Member
 
Joined: Jul 2002
Posts: 2,467
From: Portland, OR
Default

Check the hydraulics, maybe the line burst or the slave finally gave out.
Old Feb 9, 2005 | 08:09 PM
  #8  
crackheadmel's Avatar
Senior Member
 
Joined: Jul 2003
Posts: 119
From: New Hampshire
Default

I had a similar problem. I just adjusted the clutch peddle rod thing under the dash till my problems went away
Old Feb 9, 2005 | 08:52 PM
  #9  
Seppuku's Avatar
Senior Member
 
Joined: Mar 2002
Posts: 2,723
From: Ky
Default

Originally Posted by 89 Rag' date='Feb 9 2005, 07:30 PM
Check the hydraulics, maybe the line burst or the slave finally gave out.

If that were the case it would be noticable in the pedal pressure and everything.
Old Feb 9, 2005 | 10:11 PM
  #10  
j9fd3s's Avatar
Senior Member
 
Joined: May 2002
Posts: 22,465
From: California
Default

Originally Posted by Seppuku' date='Feb 9 2005, 06:52 PM
If that were the case it would be noticable in the pedal pressure and everything.



maybe, with the engine running all it takes is the slave not to move all the way

Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:36 AM.