NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   2nd Generation Specific (https://www.nopistons.com/2nd-generation-specific-17/)
-   -   Possible Bad Tranny? (https://www.nopistons.com/2nd-generation-specific-17/possible-bad-tranny-44529/)

brett vance 02-09-2005 08:13 AM

Tranny might be shot, but not sure. It won't go into gear. Tranny is manual shift. stuck in nuetral. I backed the car up ok, went to put in first and wouldn't go, as a matter of fact it wouldn't go into anygear, not even back in reverse. Any suggestions as to what to look for? If i can repair or replace a part without replacing the tranny I just might. As a second question, if tranny is bad, where can I get a rebuilt or new tranny for my '86 gxl?

j9fd3s 02-09-2005 08:59 AM

so its stuck in reverse? try loosening the backup light switch, it unscrews. if that fixes it add a washer between it and the trans

phinsup 02-09-2005 09:01 AM

Can you put it in gear with the engine off?

sureshot 02-09-2005 11:01 AM

Just to verify the symtoms:

The shift lever is in neutral but the tranny is in Reverse?

brett vance 02-09-2005 04:04 PM


Originally Posted by j9fd3s' date='Feb 9 2005, 10:58 AM
so its stuck in reverse? try loosening the backup light switch, it unscrews. if that fixes it add a washer between it and the trans







Originally Posted by phinsup' date='Feb 9 2005, 11:01 AM
Can you put it in gear with the engine off?







Originally Posted by sureshot' date='Feb 9 2005, 01:00 PM
Just to verify the symtoms:

The shift lever is in neutral but the tranny is in Reverse?






1 answer for each post.

Im not exactly sure that it is stuck in reverse, unless I just described the symptoms of a vehicle stuck in reverse.



I can put the vehicle into gear while it is off, however when the vehicle is on, nuetral is all I can get.



so to say that it's stuck in reverse I can't. But to say that the last gear I had it in was reverse, prior to the tranny doing what it's doing. I can say YES. I was backing the car out of my garage, I took the car out of reverse and went to put it into first gear and thats when I couldn't get any gear to work. I can put it in gear with the car off, but if I leave it in gear and turn it on, I tryed once and the car stalled out right away.Engine turned right back over on a restart but I couldn't get the car to move.



Maybe this might help. With the car off and set to nuetral it rolled back into the garage very easy. If it were stuck in reverse I don't believe I could do that?.



brett

Seppuku 02-09-2005 04:17 PM

If it was stuck in reverse it wouldnt roll something with your clutch is messed up.

89 Rag 02-09-2005 06:30 PM

Check the hydraulics, maybe the line burst or the slave finally gave out.

crackheadmel 02-09-2005 08:09 PM

I had a similar problem. I just adjusted the clutch peddle rod thing under the dash till my problems went away

Seppuku 02-09-2005 08:52 PM


Originally Posted by 89 Rag' date='Feb 9 2005, 07:30 PM
Check the hydraulics, maybe the line burst or the slave finally gave out.


If that were the case it would be noticable in the pedal pressure and everything.

j9fd3s 02-09-2005 10:11 PM


Originally Posted by Seppuku' date='Feb 9 2005, 06:52 PM
If that were the case it would be noticable in the pedal pressure and everything.




maybe, with the engine running all it takes is the slave not to move all the way


All times are GMT -5. The time now is 09:41 PM.


© 2024 MH Sub I, LLC dba Internet Brands