After I got all the problems sorted out (first i wired cas wrong and then there was no power to coils and then my primary injectors wouldn't fire) it finally started, smoked ALOT and ran very rich (Wideband said 10.5 AFR) because my map sensor is wired wrong (haltech is reading 207Kpa manifold pressure (like 30psi) so it is injecting HUGE amounts of fuel. Shoots huge flames, idles and runs like a v8 all of my neighboors say. Pops alot. Everytimg i rev past 3k it shoots a 3foot flame. Will get some video if anybody cares! This is an 16 year old who just dumped 5k into this project, started 2 months just now got it to run poorly heh.

 

Should have gone more slowly and thuroughly with the haltech install. Then again I've got my online tech mike to help me every second of the way :bigok: . So why didn't the primaries fire? How did you figure out you rewired a lot of stuff wrong? Just went back over it? O and get use some pixs, how did u ever mount the tps and where did u mount the water temp senor? And no my car isn't done yet, I just dropped loot on a new comp.

 

Are you following the hitman's instructions to he letter? When I installed my haltech, it fired right up.



C

 

Yeah I followed hitmans instructions, I wasn't getting a trigger so i went back and checked my cas and found I wired it wrong. I did go slow. I used s5 tps instead of the gm one. I put the temp sensor in the same place that the old temp sensor went. Try to get some pics. Think I fixed the map problem.

 

yea lets see some pixs

 

yah lets see pics



mike

 

Get some video man. ****, I'd run it like that..haha

 

video- 3ft flames- NOW

 

easy there buddy..we dont want a firery death for this poor guys new baby now do we? :bigok: