did you reuse the pressure plate?

 

No, all new clutch, pressure plate and throw-out bearing

 

How long did you drive it with the clutch bad?

 

In my opinion I would have yanked the flywheel off, and had it turned anyway, some flywheels have balance weights attached to them which can subsequently fall off under certain circumstances. Usually a machine shop would check this while servicing the flywheel.

 

I drove it about 4 miles, never above 3k

 

Did you replace the pilot bearing? If you don't have a pilot bearing, that shaft is goign to vibrate inside the eccentric shaft either way.



C

 

No new pilot bearing...could that really be the source of my problems?