I am looking for a stnd, or even a sketch so I can build a stand to run my rotary with a stock fuel tank, wiring harness and tranny hooked up to the motor. I want to be able to troule shoot and work on the engine and prefrom test runs on the motor pulled out the original car.

ANY IDEAS?

 

I use a steel table big enough to put a transmission bell housing on it with the engine attached and set a radiator in front of it. But, I don't use any factory pieces for the running of it. Carb, distributor, header, fuel pump hanging on the wall and a 5 gallon gas tank on the floor. Much simplier for me. Using the factory stuff is way to time consuming to hook everything up. Check out the video called engineonstand.avi at the link below.





http://www.vosko.net/media/rotary/