full-cruise

BOV stoped working?



i went to a FMIC and sense then its not opening up any more. i connected it back to the same vacuum it was on b4 then i tried it on another vacuum and it still stayed closed.



its a epexi twin, could it be the BOV it self or is it that im not getting up enough boost to get this open.. pulled it to 5k rpm in second close to 10 pounds and it just threw it back down into the turbo.



is there any body out there who had this problem with this BOV or doing this conversion?

slimeball

hummm have you pulled it off and tryed to depress the piston in it ? to see if it is even moveing. then mabey lube it up and try that. and losen the testion on it to it is a skrew on the top i think for that one but im not sure hope that helps

phinsup

Do you have a boost guage on it?



Did it work before?

1988RedT2

Pull the BOV, apply a vacuum source, and see if it opens.

full-cruise

[quote name='phinsup' date='May 7 2005, 02:11 PM']Do you have a boost guage on it? yes



Did it work before? yes


[/quote]

full-cruise

well it works but its just not making any noise when it blows off anymore.

RXTek

Depending on where you have it mounted you might not have enough pressure build up to make it pop open.

full-cruise

looks like **** but everythings getting powdercoated in a few weeks. but i think its in a good spot.. i realy dont care if there not a sneez every time i shift or get n it lol just as long as its working im ood to go

sureshot

No worries as long as the boost gauge does not show a spike.

full-cruise

i turned the MBC all the way down and its only reading 4lbs of boost no spiking so far