5lug Conversion...
#15
Originally Posted by Baldy' date='Apr 22 2003, 04:10 AM
I am actually about to do my 5 lug swap in about a week. My rotors, calipers, and hubs are all together in one piece. I'm just going to detach the 3 (I think) mounting bolts holding it all on, and swap them like that. The only part I'm worried about is the rear hubs, but that's just because I haven't read up on how to remove them yet. I'll be borrowing an impact drill and air compressor for the job, as suggested by fellow foruminians.
Anyone see any problem with that plan? Will I need to do anything with bearings, or the grease in them? Should I get the calipers rebuilt, or do they normally stay good? Should I get the rotors turned? The seller said they had been recently turned, but now they're covered with rust.
Anyone see any problem with that plan? Will I need to do anything with bearings, or the grease in them? Should I get the calipers rebuilt, or do they normally stay good? Should I get the rotors turned? The seller said they had been recently turned, but now they're covered with rust.
just take them appart... best to use a nice air copmpressor... but they should come out with a fairly small one too
then just inspect and replace any parts you need
did mine a couple of weeks ago it took a bit but got the job done nicely.. have all the hubs and brakes assembled just need to do the conversion
Thread
Thread Starter
Forum
Replies
Last Post
Leetheslacker
RX-7 & RX-8 Parts For Sale & Wanted
0
10-16-2007 02:27 PM
87base rx-7
RX-7 & RX-8 Parts For Sale & Wanted
1
12-06-2005 09:36 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)