Single Turbo Discussion Area for discussing single turbo RX-7's.

How Much Power

Old Feb 3, 2003 | 05:27 PM
  #1  
-=RX-7 KID=-'s Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 575
From: PA Pittsburgh
Cool

I am getting a few engine mods finished on my car and i was wondering if any one would have any clue as to how much power this could possable make, and what my times could be. It's a 1993 RX-7 R1.



Ok here it is



Stage 2 Street Ported Engine

TurboNeticks T04E Turbo @ 15 PSI

Greddy Front mount intercooler

ApexI Power FC ( Programed for 15 PSI and the 1300 cc secondary inj )

1300 CC secondary injectors, stock primary

Racing fuel pump

Full 3" exhaust ( no cat )

Kumaho racing tires

HKS Cold Air Intake

H&R Racing springs

Mazda Speed re-enforced power plant frame



That's about it i know it's hard to tell but if someone has somthing close or has a good idea i'd just like a ballpark est.

Thanks



Ant recomendations would be welcome as well. :bigok:



-=RX-7 KID=-
Old Feb 3, 2003 | 05:33 PM
  #2  
Danno's Avatar
Senior Member
 
Joined: Feb 2003
Posts: 949
From: Vernon, CT
Default

Honestly I would go with a different intake. I like the Blitz sus power intake. And the tuboneticks turbo is not the trubo I would go with either. I would go with apexI for the turbo. Did you buy these part allready?
Old Feb 3, 2003 | 05:38 PM
  #3  
94touring's Avatar
Senior Member
 
Joined: Jul 2001
Posts: 3,346
From: Tulsa, OK
Default

What kind of igntion setup you gona run? That turbo depending on specs, is good for 400rwhp at that boost. Do you happen to know the specs?
Old Feb 3, 2003 | 05:57 PM
  #4  
-=RX-7 KID=-'s Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 575
From: PA Pittsburgh
Default

It's goin to be stock ingnition for now maybe i could get it uped if you have any suggestions. The only thing i am putting on it is the power FC the secondary injectors and the new fuel pump every hting else was there when i bought it.

Do you know where i could get a better used turbo?



-=RX-7 KID=-
Old Feb 3, 2003 | 05:59 PM
  #5  
Joe Flo's Avatar
Senior Member
 
Joined: Dec 2002
Posts: 1,142
From: Houston Texas
Default

Downpipe?? Pulleys?
Old Feb 3, 2003 | 06:33 PM
  #6  
94touring's Avatar
Senior Member
 
Joined: Jul 2001
Posts: 3,346
From: Tulsa, OK
Default

I am assuming the downpipe is in the kit, the pullies aren't really neseccary in my opionon. A simple igntion solution would be the HKS twin power, works wonders. Really a good idea to have that for high boost and high hp.
Old Feb 3, 2003 | 06:34 PM
  #7  
94touring's Avatar
Senior Member
 
Joined: Jul 2001
Posts: 3,346
From: Tulsa, OK
Default

Oh, and lets not forget about a clutch to support the power and a blow off valve.
Old Feb 3, 2003 | 06:48 PM
  #8  
Danno's Avatar
Senior Member
 
Joined: Feb 2003
Posts: 949
From: Vernon, CT
Default

what kind of BOV you gonna run? I would recoment the HKS super sequential. Its i think the best one the market and no leaks.
Old Feb 3, 2003 | 06:58 PM
  #9  
r_xplicit's Avatar
Senior Member
 
Joined: Sep 2002
Posts: 1,305
From: jackson, ms
Default

go to the "post your single turbo set-up" thread, it is sticky, and i bet that you find what you are looking for or something in that area.



your power will be stabilized with the ignition, but will be non exsistent if you do not have an upgraded clutch...



louis
Old Feb 3, 2003 | 07:10 PM
  #10  
-=RX-7 KID=-'s Avatar
Thread Starter
Senior Member
 
Joined: Jan 2003
Posts: 575
From: PA Pittsburgh
Default

It has a bonez downpipe, stock pully system thou. Yea i was thinking about a ACT street/strip clutch. Oh it also all ready has a BOV i'm pretty sure it's a HKS. I'll look into that HKS ingnition system thanks. Also i was wondering where i coudl get a list of turbos to upgrade to i'd like to get arounf 600 hp when i'm all done. i relize i'm prob goin to have to get some other stuff to do that but if any one has any suggestions my goal is a 11.5 Quater mile.



-=RX-7 KID=-

Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:38 PM.