NoPistons -Mazda Rx7 & Rx8 Rotary Forum

NoPistons -Mazda Rx7 & Rx8 Rotary Forum (https://www.nopistons.com/)
-   Single Turbo Discussion (https://www.nopistons.com/single-turbo-discussion-13/)
-   -   How Much Power (https://www.nopistons.com/single-turbo-discussion-13/how-much-power-11722/)

-=RX-7 KID=- 02-03-2003 05:27 PM

I am getting a few engine mods finished on my car and i was wondering if any one would have any clue as to how much power this could possable make, and what my times could be. It's a 1993 RX-7 R1.



Ok here it is



Stage 2 Street Ported Engine

TurboNeticks T04E Turbo @ 15 PSI

Greddy Front mount intercooler

ApexI Power FC ( Programed for 15 PSI and the 1300 cc secondary inj )

1300 CC secondary injectors, stock primary

Racing fuel pump

Full 3" exhaust ( no cat )

Kumaho racing tires

HKS Cold Air Intake

H&R Racing springs

Mazda Speed re-enforced power plant frame



That's about it i know it's hard to tell but if someone has somthing close or has a good idea i'd just like a ballpark est. https://www.nopistons.com/forums/pub...#>/biggrin.png

Thanks



Ant recomendations would be welcome as well. :bigok:



-=RX-7 KID=-

Danno 02-03-2003 05:33 PM

Honestly I would go with a different intake. I like the Blitz sus power intake. And the tuboneticks turbo is not the trubo I would go with either. I would go with apexI for the turbo. Did you buy these part allready?

94touring 02-03-2003 05:38 PM

What kind of igntion setup you gona run? That turbo depending on specs, is good for 400rwhp at that boost. Do you happen to know the specs?

-=RX-7 KID=- 02-03-2003 05:57 PM

It's goin to be stock ingnition for now maybe i could get it uped if you have any suggestions. The only thing i am putting on it is the power FC the secondary injectors and the new fuel pump every hting else was there when i bought it.

Do you know where i could get a better used turbo?



-=RX-7 KID=-

Joe Flo 02-03-2003 05:59 PM

https://www.nopistons.com/forums/pub...IR#>/dunno.gif https://www.nopistons.com/forums/pub...IR#>/dunno.gif Downpipe?? Pulleys?

94touring 02-03-2003 06:33 PM

I am assuming the downpipe is in the kit, the pullies aren't really neseccary in my opionon. A simple igntion solution would be the HKS twin power, works wonders. Really a good idea to have that for high boost and high hp.

94touring 02-03-2003 06:34 PM

Oh, and lets not forget about a clutch to support the power and a blow off valve.

Danno 02-03-2003 06:48 PM

what kind of BOV you gonna run? I would recoment the HKS super sequential. Its i think the best one the market and no leaks.

r_xplicit 02-03-2003 06:58 PM

go to the "post your single turbo set-up" thread, it is sticky, and i bet that you find what you are looking for or something in that area.



your power will be stabilized with the ignition, but will be non exsistent if you do not have an upgraded clutch...



louis

-=RX-7 KID=- 02-03-2003 07:10 PM

It has a bonez downpipe, stock pully system thou. Yea i was thinking about a ACT street/strip clutch. Oh it also all ready has a BOV i'm pretty sure it's a HKS. I'll look into that HKS ingnition system thanks. Also i was wondering where i coudl get a list of turbos to upgrade to i'd like to get arounf 600 hp when i'm all done. i relize i'm prob goin to have to get some other stuff to do that but if any one has any suggestions my goal is a 11.5 Quater mile.



-=RX-7 KID=-


All times are GMT -5. The time now is 10:37 AM.


© 2024 MH Sub I, LLC dba Internet Brands