How Much Power
02-03-2003, 05:27 PM
#1
Senior Member
Thread Starter
Join Date: Jan 2003
Location: PA Pittsburgh
Posts: 575
I am getting a few engine mods finished on my car and i was wondering if any one would have any clue as to how much power this could possable make, and what my times could be. It's a 1993 RX-7 R1.
Ok here it is
Stage 2 Street Ported Engine
TurboNeticks T04E Turbo @ 15 PSI
Greddy Front mount intercooler
ApexI Power FC ( Programed for 15 PSI and the 1300 cc secondary inj )
1300 CC secondary injectors, stock primary
Racing fuel pump
Full 3" exhaust ( no cat )
Kumaho racing tires
HKS Cold Air Intake
H&R Racing springs
Mazda Speed re-enforced power plant frame
That's about it i know it's hard to tell but if someone has somthing close or has a good idea i'd just like a ballpark est.
Thanks
Ant recomendations would be welcome as well. :bigok:
-=RX-7 KID=-
Ok here it is
Stage 2 Street Ported Engine
TurboNeticks T04E Turbo @ 15 PSI
Greddy Front mount intercooler
ApexI Power FC ( Programed for 15 PSI and the 1300 cc secondary inj )
1300 CC secondary injectors, stock primary
Racing fuel pump
Full 3" exhaust ( no cat )
Kumaho racing tires
HKS Cold Air Intake
H&R Racing springs
Mazda Speed re-enforced power plant frame
That's about it i know it's hard to tell but if someone has somthing close or has a good idea i'd just like a ballpark est.
Thanks
Ant recomendations would be welcome as well. :bigok:
-=RX-7 KID=-
02-03-2003, 05:33 PM
#2
Senior Member
Join Date: Feb 2003
Location: Vernon, CT
Posts: 949
Honestly I would go with a different intake. I like the Blitz sus power intake. And the tuboneticks turbo is not the trubo I would go with either. I would go with apexI for the turbo. Did you buy these part allready?
02-03-2003, 05:57 PM
#4
Senior Member
Thread Starter
Join Date: Jan 2003
Location: PA Pittsburgh
Posts: 575
It's goin to be stock ingnition for now maybe i could get it uped if you have any suggestions. The only thing i am putting on it is the power FC the secondary injectors and the new fuel pump every hting else was there when i bought it.
Do you know where i could get a better used turbo?
-=RX-7 KID=-
Do you know where i could get a better used turbo?
-=RX-7 KID=-
02-03-2003, 06:33 PM
#6
Senior Member
Join Date: Jul 2001
Location: Tulsa, OK
Posts: 3,346
I am assuming the downpipe is in the kit, the pullies aren't really neseccary in my opionon. A simple igntion solution would be the HKS twin power, works wonders. Really a good idea to have that for high boost and high hp.
02-03-2003, 06:58 PM
#9
Senior Member
Join Date: Sep 2002
Location: jackson, ms
Posts: 1,305
go to the "post your single turbo set-up" thread, it is sticky, and i bet that you find what you are looking for or something in that area.
your power will be stabilized with the ignition, but will be non exsistent if you do not have an upgraded clutch...
louis
your power will be stabilized with the ignition, but will be non exsistent if you do not have an upgraded clutch...
louis
02-03-2003, 07:10 PM
#10
Senior Member
Thread Starter
Join Date: Jan 2003
Location: PA Pittsburgh
Posts: 575
It has a bonez downpipe, stock pully system thou. Yea i was thinking about a ACT street/strip clutch. Oh it also all ready has a BOV i'm pretty sure it's a HKS. I'll look into that HKS ingnition system thanks. Also i was wondering where i coudl get a list of turbos to upgrade to i'd like to get arounf 600 hp when i'm all done. i relize i'm prob goin to have to get some other stuff to do that but if any one has any suggestions my goal is a 11.5 Quater mile.
-=RX-7 KID=-
-=RX-7 KID=-