What About Exhuast Port Sleeves For P-port Intake?
#1
Has anyone ever tried to make a pport motor with exhuast sleeves in the intake ports?
Would this be useless?Or would it keep a good idle but alot more power than a big street port?
Also if someone went with a custom p-port 3 rotor,does it idle alot smoother than a 2 rotor?
Or if you made a shortened 3rotor pport engine, couldnt you shorten the sideplates so much?I know it would require new thru bolts and eshaft.that isnt the question.
What im saying is if a person went with a shortened 3 rotor pport engine, could they use exhuast sleeves to calm down the idle?Or does a pport not act the same as far as idle goes on a 3 rotor?
thanx
Would this be useless?Or would it keep a good idle but alot more power than a big street port?
Also if someone went with a custom p-port 3 rotor,does it idle alot smoother than a 2 rotor?
Or if you made a shortened 3rotor pport engine, couldnt you shorten the sideplates so much?I know it would require new thru bolts and eshaft.that isnt the question.
What im saying is if a person went with a shortened 3 rotor pport engine, could they use exhuast sleeves to calm down the idle?Or does a pport not act the same as far as idle goes on a 3 rotor?
thanx
Thread
Thread Starter
Forum
Replies
Last Post
MARKHBCA
2nd Generation Specific
4
07-05-2008 05:05 PM
renns
Rotary Engine Building, Porting & Swaps
14
01-10-2005 05:05 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)