For Anyone Who Has Built A Motor
#1
I have built my first turbo II motor, I used a racing beat port plate on the primary or the middle piece. I cleaned and polished the outer housings ports. My question is should this be a lumpy idle motor, I cant get it to idle smooth or below 1000rpm . This is my first motor and I have high expectations. Oh ya I just slightly extended the port a little higher just a fraction. Also the exhaust ports I d'ed out just a little.
any help is appreciated
Chris
any help is appreciated
Chris
#4
My idle sounded like a cammin' v8 until I discovered my new injectors were high impedance, on a low impedance car, it was running very rich. If you've changed injectors double check that you have the right impedance, if they're high, and you have a resistor pack
for low impedance injectors still on the harness you need to bypass it.
After I corrected that everything was much better, does your car seem to be running rich at idle? smoking and stinking?
for low impedance injectors still on the harness you need to bypass it.
After I corrected that everything was much better, does your car seem to be running rich at idle? smoking and stinking?
#5
all very good points thanks, all of you. once i get the motor BACK together again Ill check all of that especially since i have RC eng 550 injectors for primarys. Yeah a piece of the metal that keeps the seal in place broke off into the water jacket. Thank god I just happen to have a spare center housing. I'll try again.
Chris
Chris
Thread
Thread Starter
Forum
Replies
Last Post
Str8ryd
RX-7 & RX-8 For Sale
2
09-15-2007 02:52 PM
Turbo II-FB
RX-7 & RX-8 Parts For Sale & Wanted
2
02-02-2006 08:15 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)