TheCamel

I am in the process of building custom rails for the FC guys, and I am sorry to say, but that is some pretty shady workmanship. I would really consider sending them back and ordering from a different company.

Sinful7

yeah, those threads look terrible. they definetly should replace that sucker.

an_juan

I will talk to the vendor today. I needed a sanity check. Thanks for all your inputs.

pengaru

is that the k2rd rail?

an_juan

well, I'm not getting any response from them. So here goes:



K2RD. The fuel rail is for a 20b engine.



....and to think, I was going to buy a Haltech E11 from them as well......

Sinful7

did ya try calling 'em? Jut say that you're concerned about the thread quality and see what they recommend.

sleeper7

an_juan

I ordered a fuel rail from ATP Turbo. It also looked like the one you have. Very poor workmanship. I could only get the fitting to go in one complete thread. Again very poor workmanship and quality control. Called and e-mailed them. Said they would send another one but 2 months later and still no replacement. Good luck with getting this corrected. I think if it was a defective part they would resolve this but it is there workmanship that is questioned.

chuck

an_juan

k2rd told me that they will replace it with another one. Let's see if they'll follow through.......