Greddy Profec E-01 And Apex-i Pfc
#1
I am using a greddy profec e-01 and an Apex-i Power fc... The problem is that the boost on the secondary turbo does not go above 10 psi... Even if i set it to .85 on the power fc and +35% on the profec....
my primary turbo at times hits 12 psi + but the secondary does not go above 10... Infact it drops to around 9.5 .....
can it be that i have connected the boost controller solonoid on the wrong actuator??
On a different note.. I never knew how good a fully functional sequential setup feels.... Its amazing... no lag... I luv it... need more top end and then i am good to go...
Can someone give me info on the boost controller hookup... Just the vaccums i need to plug and where to connect the solonoid... so that i can recheck if i did it correctly...
Thanks
my primary turbo at times hits 12 psi + but the secondary does not go above 10... Infact it drops to around 9.5 .....
can it be that i have connected the boost controller solonoid on the wrong actuator??
On a different note.. I never knew how good a fully functional sequential setup feels.... Its amazing... no lag... I luv it... need more top end and then i am good to go...
Can someone give me info on the boost controller hookup... Just the vaccums i need to plug and where to connect the solonoid... so that i can recheck if i did it correctly...
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
RNITTO
RX-7 & RX-8 Parts For Sale & Wanted
6
12-28-2005 05:39 PM
TURBOX2
RX-7 & RX-8 Parts For Sale & Wanted
1
11-18-2005 09:12 PM
Rx7aholic
RX-7 & RX-8 Parts For Sale & Wanted
3
01-16-2004 01:08 PM
envymejoshua
RX-7 & RX-8 Parts For Sale & Wanted
0
01-25-2003 08:17 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)