I am using a greddy profec e-01 and an Apex-i Power fc... The problem is that the boost on the secondary turbo does not go above 10 psi... Even if i set it to .85 on the power fc and +35% on the profec....



my primary turbo at times hits 12 psi + but the secondary does not go above 10... Infact it drops to around 9.5 .....



can it be that i have connected the boost controller solonoid on the wrong actuator??



On a different note.. I never knew how good a fully functional sequential setup feels.... Its amazing... no lag... I luv it... need more top end and then i am good to go...



Can someone give me info on the boost controller hookup... Just the vaccums i need to plug and where to connect the solonoid... so that i can recheck if i did it correctly...



Thanks

Some Feedback Please https://www.nopistons.com/forums/pub...>/rolleyes.gif