Okay, so I made the switch to a 4 door
#1
Okay so I'm new to toyota/1JZ's. Here's a few pics of my Mark II.
Mark II Tourer V stock front end cut out for my GT-R intercooler.
Engine Bay picture. Cusco STB with master cylinder brace/stopper
Close up of the stopper
Engine torque brace.
Oil filter relocated to where the stock battery is located. I did it so I could add in an oil cooler.
Setrab 25 Row oil cooler.
Passenger side shot of the interior
Drivers side shot of the interior
Stock RX7 Seat...and baby seat.
SSR Integral GT-1 with mismatched lug nuts
This thing's got A/C, P/S seating for 5 and 300+ ft/lbs. of torque...fun to drive! No top end whatsoever...but it gets me to/from work and is still relatively fast.
Mark II Tourer V stock front end cut out for my GT-R intercooler.
Engine Bay picture. Cusco STB with master cylinder brace/stopper
Close up of the stopper
Engine torque brace.
Oil filter relocated to where the stock battery is located. I did it so I could add in an oil cooler.
Setrab 25 Row oil cooler.
Passenger side shot of the interior
Drivers side shot of the interior
Stock RX7 Seat...and baby seat.
SSR Integral GT-1 with mismatched lug nuts
This thing's got A/C, P/S seating for 5 and 300+ ft/lbs. of torque...fun to drive! No top end whatsoever...but it gets me to/from work and is still relatively fast.
#4
The valvetrain is good to 8000 rpms. The REV cut is at 7500 rpms. I shift at 7200~. Once I figure out what I'm going to do for standalone I'll shift at 7700~. I have an HKS GT3040 kit ready, but I've been thinking about going to GT35R and 22 psi on 95 pump gas. Maybe 26 psi if tuning allows for it. I already have the OS Giken twin plate clutch and 680cc injectors with dual walboro pumps.
Thread
Thread Starter
Forum
Replies
Last Post
Mazdabation
RX-7 & RX-8 Parts For Sale & Wanted
3
01-24-2005 05:55 PM
FCmaniac
RX-7 & RX-8 Parts For Sale & Wanted
0
09-13-2003 07:39 PM
pmr2000
2nd Generation Specific
13
10-31-2002 08:59 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)