i need help with t2 comnputers
#1
here is the problem i have a 79 rx7 i had a 6port motor with dellorto carbs , ok iblew the engine , my friend had a t2 swap , i desided to put it in the 79 i got everething on it ecept for the engine management so i went to a local rotory shop and i ask if the had a t2 harnes and everything i needed to get it running they gave me the harness ,computer coils , well everething . then i desided to bring the car infor they to get done well the did bout the motor had no compresion on the rear rotor the motor stared and i pay about 1500 to have then put in the harness . wel i took the car to the my shop with the bad motor and suposely a complete t2 wire harness , i got the motor done by a a nother engine builder now i have a good motor street port , bout the computer that i have is a a n332 and the mas is a n318 the mop is a n322 the motor is not runnig the way is supost to . what do i do ? bring it back and tell them to gime the rigth parts ? or do i go and spend more money for a stand alone wich to begine with would bean about the same that i spend for that ,
$600 +$1500 = $2100 by the way they told me that the car was gonna be runnig good with no problems
bout the motor was bad what do i do now>?
$600 +$1500 = $2100 by the way they told me that the car was gonna be runnig good with no problems
bout the motor was bad what do i do now>?
Thread
Thread Starter
Forum
Replies
Last Post
rotors_motor
2nd Generation Specific
8
07-02-2011 02:54 AM
2Lucky2tha7
Performance Mods
2
02-12-2004 09:34 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)