1979rx7

here is the problem i have a 79 rx7 i had a 6port motor with dellorto carbs , ok iblew the engine , my friend had a t2 swap , i desided to put it in the 79 i got everething on it ecept for the engine management so i went to a local rotory shop and i ask if the had a t2 harnes and everything i needed to get it running they gave me the harness ,computer coils , well everething . then i desided to bring the car infor they to get done well the did bout the motor had no compresion on the rear rotor the motor stared and i pay about 1500 to have then put in the harness . wel i took the car to the my shop with the bad motor and suposely a complete t2 wire harness , i got the motor done by a a nother engine builder now i have a good motor street port , bout the computer that i have is a a n332 and the mas is a n318 the mop is a n322 the motor is not runnig the way is supost to . what do i do ? bring it back and tell them to gime the rigth parts ? or do i go and spend more money for a stand alone wich to begine with would bean about the same that i spend for that ,

$600 +$1500 = $2100 by the way they told me that the car was gonna be runnig good with no problems

bout the motor was bad what do i do now>?

RE_TurboFB

Buy a stand alone and do it right??? try to cut your cost's buy selling stuff on ebay. turbo II ECU's sell for a "OK" price.