Well I shouldn't say cold its actually warm here.I am currently swapping a Carbed 6-port 13b into my 1988 B2200 short box pickup.What are you guys doing?

 

im rebuilding the cosmo motor again, also found out my chassis is tweeked so im currently working on straighting the floor and chassis then roll cage to strengthin everthing. and a bigger turbo set up as well as other things to the fc

 

I'm replacing the auto tranny in a Honda Accord and deciding if I'm swapping out my broke gsl-se 13b for a 2nd gen 13b or rebuilding.

 

Peripheral port 86!

 

Diff, dyno and spray. Gotta get the wideband working too. Actually, I've mostly been working on wiring someone else's car.

 

rebuilding a 13b-re full bridged. stripping the fc, fitting new body panels, having it painted, building a cage, Then swaping the re motor it into my fc, and then adding ten thousand parts to support. then crying cause im happy its so gorgous and sad i wont have any money left to drive it! so im pretty busy!

 

Pretty much a top-to-bottom rebuild of everything. Not much winter left tho.





Just got the 6-point finished...





Stripped it down, prepping for new body panels...





Going to use the body panels I used to make my SA22 bed on the car...





Old turbo on the left, new turbo on the right...



It's coming a long tho. The new rear-end is almost done. Can't wait to swap over to 5-bolt!

 

Here is my "project".







http://www.rx7club.com/showthread.php?t=497559

 

Nice bed ducktape.I was thinking of doing with my frame rusted 83.Cut the unibody off at the fire wall and go from there.Looks good.

 

Now that a crazy project.I did a similar one with my salvage yarded 84 GT-X project tho.My fuel tank was where my passanger seat is now.