Well I shouldn't say cold its actually warm here.I am currently swapping a Carbed 6-port 13b into my 1988 B2200 short box pickup.What are you guys doing?
|
im rebuilding the cosmo motor again, also found out my chassis is tweeked so im currently working on straighting the floor and chassis then roll cage to strengthin everthing. and a bigger turbo set up as well as other things to the fc
|
I'm replacing the auto tranny in a Honda Accord and deciding if I'm swapping out my broke gsl-se 13b for a 2nd gen 13b or rebuilding.
|
Peripheral port 86!
|
Diff, dyno and spray. Gotta get the wideband working too. Actually, I've mostly been working on wiring someone else's car.
|
rebuilding a 13b-re full bridged. stripping the fc, fitting new body panels, having it painted, building a cage, Then swaping the re motor it into my fc, and then adding ten thousand parts to support. then crying cause im happy its so gorgous and sad i wont have any money left to drive it! so im pretty busy!
|
Pretty much a top-to-bottom rebuild of everything. Not much winter left tho.
http://www.satc.net/rx7/cage2.jpg Just got the 6-point finished... http://www.bfhracing.org/duck/nofenders3.jpg Stripped it down, prepping for new body panels... http://www.satc.net/rx7/bed/bed02.jpg Going to use the body panels I used to make my SA22 bed on the car... http://www.ludwigmotorsports.com/rx7/gt42r.JPG Old turbo on the left, new turbo on the right... It's coming a long tho. The new rear-end is almost done. Can't wait to swap over to 5-bolt! |
|
Nice bed ducktape.I was thinking of doing with my frame rusted 83.Cut the unibody off at the fire wall and go from there.Looks good.
|
Originally Posted by nismo convert' post='807018' date='Mar 9 2006, 04:21 PM
|
All times are GMT -5. The time now is 10:44 AM. |
© 2024 MH Sub I, LLC dba Internet Brands