Does any body know how to eliminate the need to push the clutch peddle down to start the car. My starter switch is acting up, and I know there is a way to bridge two of the fuses with a peace of wire using the fuse box that is down by the clutch peddle. And by doing that I would eliminate the need for me to press the clutch in to start the car. I need to know which fuses to bridge.



Thank's

 

I have a factory wiring manual, but its at home and im not. I could check for ya, or you could just look under the dash at the clutch pedal and trace the wires to the fuse panel or just do it right at the switch. Im not sure if its normally open or closed Just check it w, a multimeter.

 

Clutch switch might be going bad. I got a parts car you can grab one out of.

 

Got a dash in that parts car?

 

When did you get that parts car of your's, because me and you just might have to talk about some interior parts.

 

Also the switch is good but there is a plastic peace that branches off of the clutch peddle and pushes in the trigger for the switch, and a part of it broke off. So that seems to be the problem. But I would rather bypass the sensor any way.