FikseRxSeven

i was looking for that..... thanks bobby.



well, updates.... the clutch gets stuck all the way at the bottom for a couple of seconds sometimes, but as long as i still have my strong left leg...... i can still drive the car

turbovr6

if you mean the pedal gets stuck at the floor sometimes, then you def. have air. either the fluid is too low and you sucked in air, or the master or slave is shot and you are drawing air into the sytem that way.

I can do it for you if you like. M-F 7:30 - 2:30

Danomite

you need to get youself a mity-vac (?) for bleading and make sure someone else is there to watch the fluid level as you bleed the slave cylinder. If you are doing it the old-fashioned way and pumping the pedal then it will stick after you pleed the pressure. Just lift the pedal back up (after the bleed screw is closed) and wait a sec for the master cyl to fill again...repeat.

If you still have problems then do as vosko says

RX73rdgen

Yup. Same thing just happended to me. Clutch was sticking. Clutch Master Cyclinder or Slave Cylinder.

FikseRxSeven

if you mean the pedal gets stuck at the floor sometimes, then you def. have air. either the fluid is too low and you sucked in air, or the master or slave is shot and you are drawing air into the sytem that way.

I can do it for you if you like. M-F 7:30 - 2:30 [/quote]

jay i might have to take you up on your offer.......... address please