Need Some Tips After Engine Rebuild
#1
Guys I need some tips for what to do after having the motor rebuilt.
First I was told there may be a right and a wrong way to reinstall the main pulley. I see the two little pins but are they offset at all in a way that I can't make a mistake?
Once everything is back in what things do I need to do before I start it up? I imagine one would be pressurize the fuel system but what other things should I be sure to do. I referenced the service manual and it just says fill up the fluids and start it. Any input or hints you guys can provide me would be greatly appreciated.
-Nic
First I was told there may be a right and a wrong way to reinstall the main pulley. I see the two little pins but are they offset at all in a way that I can't make a mistake?
Once everything is back in what things do I need to do before I start it up? I imagine one would be pressurize the fuel system but what other things should I be sure to do. I referenced the service manual and it just says fill up the fluids and start it. Any input or hints you guys can provide me would be greatly appreciated.
-Nic
#3
With the FD, the main pulley only goes on one way. Either all the bolts line up or they don't.
Do just what Dave said and crank it over a few times without starting to let the oil start passing into the engine.
Do just what Dave said and crank it over a few times without starting to let the oil start passing into the engine.
#5
Thanks guys. I looked at the pulley closer after I posted and noticed that the holes don't line up when it's put on one way. I have to wait for a couple of gaskets and one of the OMP fittings before I can get a good start, needed time to fix the omp wires anyway.
-Nic
-Nic
Thread
Thread Starter
Forum
Replies
Last Post
Judge Ito
Rotary Engine Building and Porting FAQ Section
18
02-28-2006 02:08 PM
agrabau
3rd Generation Specific
21
11-08-2005 04:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)