Guys I need some tips for what to do after having the motor rebuilt.
First I was told there may be a right and a wrong way to reinstall the main pulley. I see the two little pins but are they offset at all in a way that I can't make a mistake? Once everything is back in what things do I need to do before I start it up? I imagine one would be pressurize the fuel system but what other things should I be sure to do. I referenced the service manual and it just says fill up the fluids and start it. Any input or hints you guys can provide me would be greatly appreciated. -Nic |
Crank it few times without letting it start to build oil pressure.
|
With the FD, the main pulley only goes on one way. Either all the bolts line up or they don't.
Do just what Dave said and crank it over a few times without starting to let the oil start passing into the engine. |
installing the main pully has to do with the needle bearing dropping down.
none of the pullies can be mounted incorrectly |
Thanks guys. I looked at the pulley closer after I posted and noticed that the holes don't line up when it's put on one way. I have to wait for a couple of gaskets and one of the OMP fittings before I can get a good start, needed time to fix the omp wires anyway.
-Nic |
All times are GMT -5. The time now is 06:14 PM. |
© 2024 MH Sub I, LLC dba Internet Brands