Been To Dyno

Reply Subscribe

Thread Tools

Search this Thread

06-13-2003, 04:34 PM

royston1xxx

Junior Member

Thread Starter

Join Date: Dec 2002

Posts: 23

Went to a dyno yesterday(dyno dynamics) got 330.5fwhp at 7100rpm and 284 ftlb of torque at 5400rpm at 11psi boost,is this good for my mods or not? My mods are intake,dp,mp,blitz nur catback,fmic,bosch 044 pump and fpr,1200cc sec and exhaust ports slightly enlarged.Hopefully there is a graph with this post if i managed to get it to work,if not can i mail it to one of you to post for me.Thanks Roy uk.

Attached Thumbnails

06-13-2003, 04:42 PM

royston1xxx

Junior Member

Thread Starter

Join Date: Dec 2002

Posts: 23

graph 2( boost)

Attached Thumbnails

06-13-2003, 04:46 PM

j9fd3s

Senior Member

Join Date: May 2002

Location: California

Posts: 22,465

thats good for 11psi

mike

06-13-2003, 04:47 PM

dvls-7

Senior Member

Join Date: Dec 2002

Location: Ft Lauderdale, FL

Posts: 408

thats odd i thought rx7s got all its power from rwhp.....but 330.5fwhp is very impressive......the torque steer must be a bitch....

06-13-2003, 04:51 PM

royston1xxx

Junior Member

Thread Starter

Join Date: Dec 2002

Posts: 23

The dyno shows boost as .78bar (taken from the manifold nipple)but during the run my boost controller (connected to the boost sensor)was showing .9 to .95 bar,which reading is most likely to be correct? Thanks Roy uk.

06-13-2003, 05:07 PM

9BASE3

Senior Member

Join Date: Feb 2002

Location: Frederick MD

Posts: 6,331

I would think the manifold nipple would be right on... As that's where the pressure is. BUT the map sensor SHOULD be the accurate one, seeing as how its the one that talks to the ECU... HMMMM...