Went to a dyno yesterday(dyno dynamics) got 330.5fwhp at 7100rpm and 284 ftlb of torque at 5400rpm at 11psi boost,is this good for my mods or not? My mods are intake,dp,mp,blitz nur catback,fmic,bosch 044 pump and fpr,1200cc sec and exhaust ports slightly enlarged.Hopefully there is a graph with this post if i managed to get it to work,if not can i mail it to one of you to post for me.Thanks Roy uk.

graph 2( boost)

thats good for 11psi



mike

thats odd i thought rx7s got all its power from rwhp.....but 330.5fwhp is very impressive......the torque steer must be a bitch.... https://www.nopistons.com/forums/pub...#>/biggrin.png

The dyno shows boost as .78bar (taken from the manifold nipple)but during the run my boost controller (connected to the boost sensor)was showing .9 to .95 bar,which reading is most likely to be correct? Thanks Roy uk.

I would think the manifold nipple would be right on... As that's where the pressure is. BUT the map sensor SHOULD be the accurate one, seeing as how its the one that talks to the ECU... HMMMM...

damn, thats only 11psi?

very good numbers with 11psi https://www.nopistons.com/forums/pub...IR#>/smile.png

haha beat me too it. Torque steer! yay https://www.nopistons.com/forums/pub...1047683329.gif