More Pics. Comments Welcome
#31
OK I have all the lines figured out, I do have to make another trip to the store and buy a couple extra fittings. One question to Justin or Keith, Why are my 2ndary injectors so tall that it wont allow the rail to seat? Is that something I was supposed to somehow modify?
#32
Originally Posted by Fd3BOOST' date='May 22 2004, 02:57 PM
OK I have all the lines figured out, I do have to make another trip to the store and buy a couple extra fittings. One question to Justin or Keith, Why are my 2ndary injectors so tall that it wont allow the rail to seat? Is that something I was supposed to somehow modify?
The injectors will seat in the rail first.. Lube up the rings a bit and pop them in there. If they aren't seated all the way, it can be tricky... If they are seated in there, then I'm not sure. There shouldn't be much space to close between the rail mounts and the LIM..
#33
Ok, am I supposed to remove the mixing plate from the LIM?
And if I am is there anything else (like the 5/8" hose insulator trick) that I should be doing? If I am not supposed to remove the mixing plates from the LIM, then these injectors do not fit. Anyone know what I am sayin?
And if I am is there anything else (like the 5/8" hose insulator trick) that I should be doing? If I am not supposed to remove the mixing plates from the LIM, then these injectors do not fit. Anyone know what I am sayin?
#35
nice cuticles there sexy.
yes they need to stay out. i dont have your number programed on my phone but i did get your VM. i am at the shore right now so i dont have any access to my phone list on my puter. sorry. try me tomorrow. i will be back for a meet in Philly so you can call all day. check your PM's too.
yes they need to stay out. i dont have your number programed on my phone but i did get your VM. i am at the shore right now so i dont have any access to my phone list on my puter. sorry. try me tomorrow. i will be back for a meet in Philly so you can call all day. check your PM's too.
#39
Originally Posted by rfreeman27' date='May 23 2004, 05:52 PM
Dave, are you gonna make a grommit to seal the injector? I used some 3/8 (iirc) heater hose...cut it a little bigger then the gap, and squeezed it down when i tightned the rail.