Full Non Sequntial
#121
Hope peolpe are still reading this thread, if so......
I went non sequential when I rebuilt my engine and have not seen steady boost since then. Had the stock pill in the line to the wastegate and would hit 15 psi's but at higher rpms this would drop to 12 or 13. Have no cats and have an intake and intercooler. Any Ideas?
I went non sequential when I rebuilt my engine and have not seen steady boost since then. Had the stock pill in the line to the wastegate and would hit 15 psi's but at higher rpms this would drop to 12 or 13. Have no cats and have an intake and intercooler. Any Ideas?
#123
gone over them all so many times, just got done puting a boost controler like in robinettes site and no matter where I adjust the boost to it drops a couple of psis in the higher rpms, do you think it could be the wastegate vs precontrol solenoid use the "Ricki" site said either one could work and I don't remember which I used.
#124
Ryan (rikki) claims to have been better off eliminating the Pre control.
If you want them switch them around and try elimintaing the one that you currently have hooked up. Also did you remember to wire the flapper door on the TCA all the way forward?
If you want them switch them around and try elimintaing the one that you currently have hooked up. Also did you remember to wire the flapper door on the TCA all the way forward?
#125
The poor mans non sequential.
Step 1.
Remove the turbo control actuator (TCA) and plug the lines with some bolts and zip ties.
Step 2.
Wire the TCA flapper door open (towards the front of the car)
Step3.
"T" the blow off and charge relief valve lvacum lines together, plug the remaining vacum line that runs from the charge relief valve to the lower intake manifold
Step4.
Remove the two vacum lines to the charge control valve and plug the remaining vacum lines.
(one from the y pipe to the charge control valve & one from the LIM to the charge control valve)
Step5.
Remove the black plastic pressure tank & plug the remaining vacum lines to the precontrol solinoid.
You should have a total of seven vacum lines plugged
Two off the LIM, one off the "Y" pipe, two off the hardpipe and two from the TCA (turbo control actuator)
-Dave
Step 1.
Remove the turbo control actuator (TCA) and plug the lines with some bolts and zip ties.
Step 2.
Wire the TCA flapper door open (towards the front of the car)
Step3.
"T" the blow off and charge relief valve lvacum lines together, plug the remaining vacum line that runs from the charge relief valve to the lower intake manifold
Step4.
Remove the two vacum lines to the charge control valve and plug the remaining vacum lines.
(one from the y pipe to the charge control valve & one from the LIM to the charge control valve)
Step5.
Remove the black plastic pressure tank & plug the remaining vacum lines to the precontrol solinoid.
You should have a total of seven vacum lines plugged
Two off the LIM, one off the "Y" pipe, two off the hardpipe and two from the TCA (turbo control actuator)
-Dave
Thread
Thread Starter
Forum
Replies
Last Post
jeusdroid27
Group Buys
0
12-27-2014 03:08 AM
jeusdroid27
Group Buys
0
12-27-2014 02:59 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)