relisys190

OK, everyone in here with a manual tranny should have this problem, downshifting, let the revvs fall below 2000 rpms. car gets lurchy and bucks right?



WEll, i heard that you can attach a 5k resistor in the wireing for the TPS (makeing the computer slow fuel flow) instead of stopping it all together. I was wondering if this works? And how does it effect Gas miliage/waistage...



Does it really stop the bucking? Cuase i get it bad. And i havnt even done the TB mod yet.

j9fd3s

if you have a good tps adjusted right they wont do that.



mike

relisys190

Really. Humm, my mechanic never told me that.



It's a new Tps too. i put her on my self. Man im an idiot : It's prolly not adjust right. I check the board for adjustments.

boxstock

It sounds more like a driver problem.

When you down shift you should try and match the revs using heel toe or ball edge shifting technique.

Unless your mechanic is rotary specific he will be confused by this engine.

relisys190

Yes, that is how i down shift. (sounds like a motorcycle) I match the revvs and put it in the lower gear. but when it's in gear and the rpms get to around 2000 it starts to buck. trust me i know about the heel/toe.. And i always use it.





Markus

winger

i got the same prob...it just needs adjustment...but rx7 suck *** @ 2k rpm

j9fd3s

yeah for some reason between 1100-1700rpms is hard



mike