rotary_revolution_0

I was just wondering if it was possible to put a small turbo on an n/a, just to give it a LITTLE boost. With the TII conversion, you need a new tranny, new powertrain if I'm not mistaken. Please tell me if a small turbo would be remotely possible.

sidewinderx7

theoretically its possible. Will it hold up? who knows... i say give it a shot and let us know how it goes!

1Revvin7

Some have done it on the forums, and all of them have blown their engines running low psi. If you're good with custom work it can be done for cheap, but you will need an s-afc, injectors, ic ect.

Midnightdriver

I don't see a problem if you get a smaller turbos wastegate actuator or hell just a small trubo but then you have the manifold to do. I don't see to much of a problem running 5psi or so. Or you could just do like many get a second job for a while. oh yes if you do go that route don't forget to add some fuel and retard the ignition or something that will do it for you.

banzaitoyota

Do it with a nice set Cosmo Twins set-up non-sequential. ~ 6 PSI of boost, add the Piggybacks and injectors you are ready yo go. I would remove the OMP completely, use the OMP mounting point as the turbo oil drain return.

Nemesis

You don't have to do the driveline right away. The T2 motor will bolt up to the N/A driveline. Just don't beat the **** out of it.

j9fd3s

bell tech had a turbo kit for the na before mazda had the t2, 238hp on a full to4. i thnk they used a rising rate fuel pressure regulator for fuel

pengaru

yeah, it shouldnt be too difficult to do.



spend some money on maximum boost by corky bell, it will help out with learning what needs to be done when force feeding the NA configuration. It has purty pictures of turbocharged race car engines too.

j9fd3s

just keep in mind some of that is corky's opinion and not actual fact/science

FaztAzzGXL

hey.. i turboed my 6 port motor.. i put a 60-1 to4e.. 550cc injectors on the secondaries.. apex afc.. im running 3-5 psi and it pulls really good for the low psi.. im getting a haltech in about a month and ill raise it to about 12 psi and see where i can go from there..